Physically
chucks were taken for demo to Machine Tool Builders factories, HMT units at
Bangalore, Kalamassery and Pinjore. Industrial Plants and Texmaco Ward.
PV
personally visited with Voltas reps to
HAL Koraput, MTPF Ambernath BHEL Tiruchy and demonstrated our chuck and gained
their acceptance in spite of lower priced scroll chuck. L. Subramaniam of our sales department was entrusted to
carry out demos. Heavy metal removal on
castings and forgings using full HP of the machine. An ammeter was used in the
electrical circuit to check how much current is drawn during machining.
Machines were unable to withstand cutting load. But the Chuck did not loose its
gripping force during machining...
 |
| Sri.K.Jagannathan |
About the author : Shri. K Jagannathan -
Executive Director – Sales & Marketing, Guindy Machine Tools Limited.
Sri.K.Jagannathan is synonymous with lathe chucks in the Indian machine tool industry. He has been with Guindy Machine Tools for over 5 decades. His vast experience and immense knowledge of workholding products is evident in some of the most complex workholding solutions provided by GMT.
Sri.K.Jagannathan is synonymous with lathe chucks in the Indian machine tool industry. He has been with Guindy Machine Tools for over 5 decades. His vast experience and immense knowledge of workholding products is evident in some of the most complex workholding solutions provided by GMT.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.